Yunfu Boson Stone Co., Ltd, a stone countertop manufacturer based in Yunfu, Guangdong, China, fabricates both sintered stone and engineered quartz vanity tops for hotel, serviced-apartment and multi-family projects. The two are often quoted side by side and specified almost interchangeably. They should not be.

Surface hardness. Sintered stone is fired at high temperature, denser and harder at the surface; in a hotel bathroom that shows up as fewer scratches around the basin, where rings, keys and cloths land. Engineered quartz is roughly 90 percent crushed quartz bound with resin — slightly softer, but more forgiving of impact at the edge.

Edge behaviour, where most failures happen. Sintered stone is brittle at a thin edge. A 12 mm sintered top with a mitred 45-degree return looks superb and is entirely practical — provided it is cut on a proper saw, polished wet, and crated so nothing loads the edge. Quartz tolerates rougher handling and site adjustment, which matters when the installation crew is not the one that made the top.

Repairability. Quartz can be sanded and re-polished on site; a chipped sintered edge generally cannot. Where protection during fit-out is limited, quartz is the lower-risk specification.

Weight and substrate. A 20 mm sintered top is heavier than the same thickness in quartz and needs a flat, fully supported substrate — no shimming under the front rail. We ask for the vanity carcass drawing, not only the top drawing, for this reason.

Silica compliance. Australia's restrictions and Europe's tightening silicosis rules both turn on crystalline silica. Zero-silicon quartz removes that question from the submittal; sintered stone is assessed on its own reports.

In one line: sintered stone where the design is exposed and the edge protected; zero-silicon quartz where the site is rough and repair matters. Both are cut to ±0.5 mm, wet-polished. Send the vanity drawing through www.bosonstone.com for an EXW Yunfu quotation.