Yunfu Boson Stone Co., Ltd, a stone countertop manufacturer based in Yunfu, Guangdong, China, sends a photo at each production stage of an order — slab selection, CNC cutting, edge profiling, dry-lay approval, crating and loading — so a problem surfaces on day three rather than the day the container is due.
The stages, and what each photo is actually for. Slab selection: which bundle, which slab, which vein direction — the record that later proves the piece matches what was approved. CNC cutting: parts laid out with the drawing beside them, which catches a mirrored piece or a wrong cut-out before the edge work begins. Edge profiling: the profile against a gauge, because a mitre that is two degrees out closes up on site and cannot be fixed. Dry-lay approval: the whole set assembled on the floor in installation order, which is the only stage where a joint that does not line up is still cheap to correct. Crating: how pieces sit in the crate, so the receiving end knows what to expect on opening. Loading: the container braced and sealed, with the count on the door.
Six photos are not a marketing gesture. They replace the site visit that most overseas buyers cannot make, and they move the decision point from the destination — where the only options are accept, rework or replace — back to our works, where the fix is a recut from the same lot.
Every order also leaves with per-piece labels in installation sequence and, where the specification requires it, SGS and CNAS test reports.
To see a sample photo set from a recent order, or to start one of your own, send drawings and quantities through www.bosonstone.com. Quotations are EXW Yunfu and engineers reply within 24 hours.
